Publicité
26. Using a sharp scalpel blade, cut a central slot in the front face of the wing leading edge on each side as shown,
about 10 mm short of the start of the rounded section. The slots should be deep enough to accommodate the
CFRP turbulators (34). Glue the carbon turbulators in the slots using UHU-por, and sand the ends back flush
with the edge of the wing once the glue has set hard.
Setting up the model
Control surface travels (for the first few flights it is sensible to limit the control surface travels to about 60% of
•
the values stated below. Do this using Dual Rates, and assign D/R switches if required):
Elevator 50 mm up, 50 mm down
Rudder
50 mm right, 50 mm left
Aileron
45 mm up, 45 mm down
Centre of Gravity position: about 75 mm from the wing root leading edge.
•
First flight: charge the batteries and check all the model's working systems. Carry out a range check. Wait for
•
a day with as little breeze as possible (flat calm is ideal). Now you are ready for the model's first flight. Ask an
experienced launcher to give the Extra a gentle hand-launch. The motor has plenty of power, and the model
does not need a powerful launch. Adjust the trims if necessary, and take your time to get to know the
aeroplane's handling characteristics before trying out aerobatics for the first time.
The following items are also required (not included in the kit)
1 x COMPACT 135 7.4 V
4 x C 1041 servo
1 x XP 10 FM 35 MHz receiver
1 x 2 LiPo 400 flight battery, 7.4 V / 0.40 Ah
Optional accessories and tools (not included in the kit)
1 x Styrofoam cyano-acrylate glue ("foam cyano")
1 x UHU POR adhesive
1 x Cyano-acrylate activator spray
1 x Sanding block
1 x Self-adhesive glass fibre tape
Radio control system
1 x mc-12 35 MHz radio control set
Other Graupner/JR 35 MHz FM radio control systems are also suitable.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
Order No. 7736
Order No. 5116.LOSE
Order No. 7020
Order No. 7606.2
Order No. 5820
Order No. 959
Order No. 953.150
Order No. 1067
Order No. 98709
Order No. 4724
26
ID# 0058873
01/2008
Publicité
