Publicité
Les langues disponibles
Les langues disponibles
BATTERY INSTALLATION FOR TIMER
Replace batteries when low-battery light is on.
Disconnect regulator from tank before
installation or replacement.
1. Locate battery cover on timer.
2. Press and slide battery cover off as shown.
3. Install 2 "AAA" Alkaline batteries. Check positive (+) and
negative (-) symbols on the case and battery to insure
proper installation.
4. Replace the battery cover.
5. For battery removal and replacement repeat this
procedure.
Keep batteries away from small children. If battery is swallowed consult a physician immediately.
Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.
MATCH LIGHT INSTRUCTIONS
1. Read all instructions and warnings before lighting.
2. Check gas control valve/regulator and gas cylinder valve to be certain it is in OFF position before
connecting to gas cylinder.
3. Perform soapy water test before each use.
4. Remove all accessories and cooking vessels from in/or on unit.
5. Turn gas cylinder valve on, then turn gas control valve/regulator on.
6. Place a long, lit fireplace match stick close enough to burner to ignite.
7. If ignition does not take place within five seconds, turn gas control valve/regulator to OFF position
and wait five minutes and repeat match light instructions.
8. After each use turn gas control valve/regulator off, then gas cylinder valve off. Always allow unit to
cool completely before touching, moving or storing.
8
CAUTION
Do not dispose of batteries in fire.
POSITIVE
NEGATIVE
BATTERY COVER
Publicité
