Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
5
CONNECTION VALVE ASSEMBLY
For pool with connection valve
NOTE:
If you want to connect other pool cleaning
kits to the pool through the connection valve, disassemble
the Debris Screen from the Connector.
1in. - 2in.
2-5 cm
8
A
FILLING POOL WITH WATER
ATTENTION:
while filling with water.
1. Fill the pool until the water reaches the welding line
located 4.7in.-7.9in. (12cm-20cm) from the top of the
pool. DO NOT OVERFILL as this could cause the pool
to collapse. In times of heavy rainfall you may need to
empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water
is not collecting on any side to ensure the pool is level.
IMPORTANT:
water and re-level ground by digging out. Never attempt
to move the pool with water in it, serious personal injury
or damage to the pool may result.
WARNING:
deal of pressure. If your pool has any bulge or uneven
side then the pool is not level, the sides may burst and
the water may discharge suddenly causing serious
personal injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check any
evident water loss. Do not add chemicals until this has
been done.
POOL MAINTENANCE
If you do not adhere to the maintenance guidelines below,
your health might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE:
Chemconnect or Chemical Floater must be
used when you perform chemical maintenance with
Do not leave pool unattended
If pool is not level, drain
Your pool may contain a great
4.7in.-7.9in.
(12cm-20cm)
0°
B
Publicité
