Master Chef 043-2338-4 Manuel Du Propriétaire page 8

TROUBLE SHOOTING
Water is leaking.
Unplug dispenser, remove bo le and replace it.
No water is coming from the spout.
Make sure the bo le is not empty. If empty, replace it.
Make sure to completely depress the push bu on controls.
Cold water is not cold.
It takes up to one hour a er setup to dispense cold water.
Make sure the power cord is properly connected to a working outlet.
Make sure the back of the dispenser is at least 20 cm from a wall and
there is free airflow on all 20 cm sides of the dispenser.
Make sure green power switch on back of dispenser is ON.
If water s ll isn't cold, contact an authorized service agent.
Hot water is not hot.
It takes 15-20 minutes a er setup to dispense hot water.
Make sure the power cord is properly connected to a workin g outlet.
Make suer red power switch on back of dispenser is ON.
Dispenser is noisy.
Make sure the dispenser is posi oned on a level surface.
CLEANING
To avoid accidents, cut off the power supply before opera on according
to the following instruc ons.
1. The machine was disinfected before being shipped from the factory. Clean
the dispenser prior to installing a full bo le of water for the fist me.
2. Cleaning and draining instruc on:
1)Make sure the power switch in the O(off) posi on and unplug the water
dispenser before cleaning.
2)Twist out the two screws, the take down top cover, cold tank cover,
and separator
3)Fill 2.2 L of pure water into cold tank to clean it.
4)Place a large water bucket beneath the drain outlet which is in the back of
the water dispenser, then remove the drain cover and drain the water.
5)Reposi on the drain cover, separator, cold tank cover, and top cover a er
draining. Ensure the pipe and wires are connected properly, then you
can use the machine normally.