Install water bo le
1. Open cabinet door.
2. Place probe assembly on probe hanger.
3. Place fresh bo le outside of cabinet.
4. Remove en re plas c cap from top of bo le.
5. Clean outside of new bo le with a cloth.
6. Place probe into bo le.
7. Slide collar down un l it clicks in place.
8. Push head down un l tube hits bo om of
bo le.
9. Slide bo le into cabinet and close door.
Powering On Dispenser
Plug cord into a properly grounded wall outlet.
At this me the pump will begin to move water
from the bo le to the hot and cold tanks. It will
take up to 12 minutes to fill the tanks for the first
me. During this period the pump will run
con nuously. This is normal.
Ac vate Hea ng & Cooling
No ce: This unit will not dispense hot or cold water un l the switches
are ac vated.
To ac vate, push top side of power switches in to start hea ng and cooling
water.
- If you do not want to heat water, push bo om side of red switch in.
- If you do not want to cool water, push bo om side of green switch in.
19 L Bo le
12 L Bo le