Table des Matières
Publicité
IV - HEADSET
The Series 6 BL is equipped with a headset jack located at the bottom of the unit below
the
microphone. Plugging in the headset allow hands-free use. To use the headset,
CALL/TALK/OFF switch must be on "TALK" (✆) position.
V - BATTERY CHECK
The Series 6 BL is powered by 4 AA batteries.
When either of the 2 switches is not in the "OFF" position, a red led, located below the switches
indicates battery power.
A steady light indicates batteries are good.
A blinking light indicates batteries should be changed. No light at all means dead batteries or
there are no batteries installed in the unit.
VI – REMPLACEMENT DES BATTERIES (Voir dessin page 10)
Les 4 piles de type AA sont situées sous le capot arrière du combiné (recouvert d'un antidérapant
en caoutchouc). A l'aide d'un tournevis, retirer les 2 vis de fixation du capot situées de part et
d'autre du mousqueton. Faire glisser vers l'arrière le capot puis soulever. Respecter les symboles
de polarité indiqués à l'intérieur.
VI - REPLACING THE BATTERIES ( S e e d r a w i n g p a g e 1 0 )
The batteries for the Series 6 BL are located under the non-slip pad/back cover.
Use a screwdriver to loosen the two screws holding the back cover in place. Slide the cover
away from the speaker grille and lift up. The batteries are the AA type. We recommend that
you use the alkaline battery type for replacement. Insert the batteries in accordance with the
symbols inside of the battery compartment.
VII- CARACTÉRISTIQUES DE FONCTIONNEMENT
Les
combinés
sont
longueur de câble de 15 km en 4/10
VII - WORKING SPECIFICATIONS
The Series 6 BL will operate up to 15 km (9.3 miles) using 26 gauge wire (4/10 millimeters)
and up to 25 km (15.5 miles) using 22 gauge wire (6/10 millimeters).
prévus
pour
assurer
e
, et de 25 km en 6/10
la communication sur une
e
.
9
Publicité
Table des Matières
