GLOBBER EVO COMFORT Mode D'emploi page 5

SCOOTER ASSEMBLY (See page 2)
EVO COMFORT is provided with an adjustable handlebar (T-bar) which can be
adapted to the child's height (4 positions). The spring-loaded ball shall be in the
hole when adjusting the T-bar height (see diagram E).
Make sure that for the lowest position of the T-bar the ball is locked into the lowest
hole (see diagram E). Loosen the quick release clamp of the handlebar (T-bar)
when adjusting. Tighten the quick release clamp to secure handlebar (T-bar) after
adjustment.
Steering: EVO COMFORT's steering responds intuitively to the movement of the
body (see diagram B).
- When the child leans to the right, EVO COMFORT turns right!
- When the child leans to the left, EVO COMFORT turns left!
For the youngest children, on flat surfaces and in straight lines, EVO COMFORT
has a steering blocking system for better balance and to make learning easier.
- To lock, press the button above (see diagram C)
- To release, press the red button below (see diagram D)
During use:
- Standing on the scooter, one hand on each handle, push with one of your feet to
move forward. Proceed with caution at the start.
- Braking: a brake is located at the rear, when necessary press down on it to slow
down. Press down gradually in order to prevent skidding or loss of stability.
- Shoes are mandatory and we strongly advise you to wear trousers and long
sleeve shirts to avoid injury if you fall.
- Explain to the child clearly how to lock the scooter before any use.
Care / Maintenance:
Regular maintenance is a safety commitment:
- Wheel bearings: avoid going through water, oil or sand as this can damage
wheel bearings.
- Wheels: the wheels wear down with time and can be damaged if overly used
on rough surfaces. The back wheel on which the brake is applied is particularly
affected after several hours of braking. In the interests of safety, they should be
checked regularly and changed if necessary.
- Modifications: the original product must by no means be modified except for
the maintenance-related changes mentioned in these instructions.
- Nuts and axles: these should also be checked regularly. They can become
loose after a while in which case they should be tightened. They can become
worn and not tightened properly, in which case they should be replaced.
- Cleaning: Clean the scooter with a soft cloth and a little water.
5