Télécharger Imprimer la page

Best IS502 Instructions page 13

Publicité

Les langues disponibles

Les langues disponibles

WIRING
Note: Electrical wiring must be done by a qualified person(s) in accordance
with all applicable codes and standards. This range hood must be properly
grounded. Turn off electrical power at service entrance before wiring.
1. Remove screws and cover from the wiring box.
2. Feed 6" of power cable through the top opening of the support frame bracket
(installed on ceiling) and into the wiring box. Secure cable to the wiring box
using an appropriate connector. Fig. 23.
3. Feed the range hoods power cable through the lower hole of the wiring box.
Fig. 23.
4. Make electrical connections. Wire white-to-white, black-to-black and green-
to-green. Fig. 23.
5. Push all wiring inside the wiring box. Reinstall the cover and screws making
sure wires are not pinched.
6. Tuck excess power cable inside the flue.
WIRING BOX
COVER
BLK-BLK
WHT-WHT
GRN-GRN
LINE IN
120 VOLTS-60 HZ
- 13 -
FIG. 23

Publicité

loading