Troubleshooting - AquaScape Ultra 400 Instructions Et Entretien

Masquer les pouces Voir aussi pour Ultra 400:

Instructions (16 pages)

Table des Matières

Les langues disponibles

1b. A centering bushing is required on both ends of the

impeller shaft; one bushing is located inside the pump

and an outer bushing sits in the Water Chamber Cover.

2. Slide the first interior bearing washer onto the ceramic shaft.

3. Place the ceramic impeller shaft into the pump, checking

to be sure the centering bushing seats inside the pump.

4. Carefully slide the impeller back onto the shaft. Use

caution: the Impeller Assembly is magnetic and will be

forcefully pulled back into the pump.

For more information about our company or products, please visit our website at www.aquascapeinc.com

91054.11276

91054 - 91005, 91006, 91007, 91008, 91009, 91010 Ultra Pump Instructions D7.indd 8

or call us at (US) 1-866-877-6637 (CAN) 1-866-766-3426

☎

US 1-866-877-6637 |

5. Install second outer bearing washer over the

impeller shaft.

6. Replace Water Chamber Assembly, containing the

impeller shaft centering bushing by sliding it over the

impeller shaft and then rotating it clockwise to lock it

into place over the tabs on the pump housing.

7. Replace the Pump Cover and Filter Sponge by snapping

them back onto the pump housing.

• Winter Storage – If concerned about possible freeze

damage, disconnect the tubing from the discharge fitting

and remove the pump from the water. Clean the pump

and inlet screens with fresh water and store the pump in

a frost-free location. The pump can be run during cold

weather, if desired, but should be removed in the event of

a power failure to prevent any freeze damage to either the

pump or the piping.