Publicité
Les langues disponibles
Les langues disponibles
ŸŸŸ
ENGLISH
3. Place the ingredients in the basket (6), close the lid (3) and insert the
plug into the power outlet. A beep will be emitted and the initial
screen "1 3:00" will appear on the display (g). The two dots ":"
between "hour" and "minutes" are lit up to indicate that the appliance
is ready to be put into operation. "1 – Pane Normale", medium crust
colour and 900 g quantity will be automatically displayed.
4. Select the type of program by pressing the MENU key (d): a beep will
be emitted each time the key is pressed, the program will change and
the corresponding number will be displayed on the screen (Table A).
5. At this point, select the crust colour preferred and the bread size
using the crust colour (a) and size (b) keys respectively. The methods
selected will be displayed on the display with two small triangles.
6. If desired, the timer can be set according to the methods described
in the section "Timer Function".
7. Press the START/STOP key (c) to start the program.The program set
starts immediately, accompanied by a beep. The ":" on the display
will start to flash and the display will signal the countdown (decreasing
as the program proceeds).
8. To interrupt a program while it is in operation, press the START/STOP
key (c) for two-three seconds until a long beep confirms the
interruption. The initial screen "1 3:00" will once again appear on the
display.
9. At the end of the kneading, rising and baking cycle, the appliance
emits a series of 10 beeps.
10. At the end of the program, the appliance keeps the bread warm for
roughly an hour and turns off automatically. If you do not require this
function, press the START/STOP key (c) after the program has
ended. A prolonged beep will confirm the removal of this function.
Then disconnect the plug from the power outlet.
NOTE WELL: If the appliance is started with an incorrect setting, press
the START/STOP key to stop the program. Enter the correct setting and
restart.
During the baking phase, steam may be generated; therefore it could
come out of the air holes of the lid.
All manuals and user guides at all-guides.com
Publicité
