Hitachi N 3804AB3 Manuel D'instructions Et De Sécurité page 14

English
To continue stapling in a separate location, move
the stapler along the workpiece, repeating steps
2 - 5 as required.
1
Push lever
WARNING
A nail will fire each time the trigger
is depressed as long as the push
lever remains depressed.
(2) Continuous operation (Push lever fire)
Using CONTACT ACTUATION MECHANISM
WARNING
To avoid double firing or accidental
firing due to recoil.
1) Do not press the stapler against the
workpiece with excessive force.
2) Separate the stapler from the
workpiece as it recoils after
stapling.
1 Set the switching device to the downward
position (to set to CONTACT ACTUATION
MECHANISM).
(Set the switching device to the downward
position completely as shown in the diagram.
Otherwise, it will not operate properly.)
2 Pull the trigger with the Stapler off the
workpiece.
3 Depress the push lever against the workpiece
to drive a staple.
14
Upward position
Switching device
3
4
T rigger
4 Move the Stapler along the workpiece with a
bouncing motion.
Each depression of the push lever will drive
a staple.
As soon as the desired number of staples have
been driven, remove finger from the trigger.
4
2
Push lever
Previously pull
the trigger
WARNING
Keep your finger off the trigger except
during fastening operation, because
serious injury could result if the push
lever accidentally contacts you or others
in work area.
Keep hands and body away from the
discharge area. The Stapler with contact
trip mechanism may bounce from the
recoil of driving a fastener and
unwanted subsequent fastener may be
driven, possibly causing injury.
Some types of loaded staples can spark
out of the muzzle during a staple driving
operation. Exercise caution!
The SINGLE SEQUENTIAL ACTUATION MECHANISM
is for use where precision fastener placement is desired.
Switching device
1 Downward position