Publicité
Les langues disponibles
Les langues disponibles
INTERMITTENT PILOT (IP) - LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This appliance is equipped with an ignition device which
automatically lights the pilot.
Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the appliance area
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire
department.
1.
STOP! Read the safety information above.
2.
Turn off all electric power to the appliance.
3.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
HONEYWELL IP SMART VALVE
4.
Remove front panel door.
1.
Turn off all electric power to the appliance if service is to
be performed.
2.
Remove front panel door.
37134-6-0520
OPERATING INSTRUCTIONS
GAS FLOW
IGNITOR
OFF
ON
CONTROL
GAS VALVE SHOWN IN OFF POSITION
TO TURN OFF GAS TO APPLIANCE
WARNING
C. Use only your hand to slide the gas control knob. Never
use tools. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
5.
Slide gas control switch to "OFF."
6.
Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
7.
Slide gas control switch to "ON".
8.
Replace front panel door.
9.
Turn on all electric power to the appliance.
10. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your service
technician or gas supplier.
3.
Slide gas control switch to "OFF."
4.
Replace front panel door.
Page 13
Publicité
