Advance Settings - SilverCrest SPMR1 B1 Instructions D'utilisation Et Consignes De Sécurité

Step 1: Press and hold the PTT button 14 . The above transmission icon
will appear in the display 1 .
Step 2: Hold the handheld transceiver at about 3 to 5 cm from your
mouth and speak into the microphone 10 .
Step 3: Release the PTT button 14 once you have completed your
message.
Battery status indicator
When the product is switched ON, the Battery level indicator 23 will
show on the top right corner of the display 1 .
Rechargeable batteries fully charged.
Rechargeable batteries 2/3 charged.
Rechargeable batteries 1/3 charged.
Rechargeable batteries empty.
When the batteries drop to 1/3 charged, a double beep tone is emitted
every 10 minutes, at this time start to charge the rechargeable batteries.
The signal tone is also emitted after each broadcast.
P Advance settings
CTCSS (Continuous Tone-Coded Squelch System)/
DCS (Digital Code Squelch)
In order to avoid receiving other signals from nearby, you can apply for
CTCSS or DCS technology by following the information detailed in this
section.
The CTCSS or DCS three-digit code is basically a tone frequency that the
handheld transceivers will use for transmission. Two handheld transceivers
that have been set to the same channel and the same CTCSS or DCS
code can listen to each other. No other transceiver will be heard on the
same channel, unless it is using the same CTCSS or DCS code.
This product supports a total of 38 analogue CTCSS (1 to 38) and 83
digital DCS (39 to 121) codes. Any receiver tuned to the same channel
and using the same CTCSS or DCS code can listen to your message.
GB/IE/NI 21