Installation And Setting - MeisterCraft PROFESSIONAL MSB 1050 E Traduction Du Manuel D'utilisation Original

5452360-Schlagbohr-man 07.05.14 14:25 Seite 37
"GS" voluntary quality mark
Housing is double insulated
CE marked (conforms to
European safety standards)
Manufacturer address
7 – Installation and setting
Inserting bit/tool
CAUTION! Always unplug before
changing bits.
To open the chuck, turn the gear ring
anticlockwise until the bit can be
inserted. If bits stick, use the chuck key.
Now at each drill hole tighten the chuck
evenly with the chuck key.
Selecting speed
WARNING! Pull out power plug.
The speed selector
I
allows you to adjust the
0
number of revolutions
All manuals and user guides at all-guides.com
of the tool to the type of material being
drilled.
• Turn the speed selector on the On-Off
• Turn the speed selector in the (+)
With the On-Off sliding switch the number
of r.p.m. can be varied continuously
within the selected maximum speed.
Percussion device/right or left-hand
rotation
in rotation; wait until the drill has come
to stop. The chucks of reversible
drills are always fixed by a screw with
a left hand thread. This screw must
be loosend before the drill chuck can
be removed and is accessible through
the front of the chuck. To loosen a
screw with a left hand thread, turn in
a clockwise direction.
switch (5) in the (–) direction. The
maximum number of r.p.m. is reduced.
direction: The number of r.p.m. is
increased up to the maximum speed.
Setting as illustrated with motor
off.
IMPORTANT! Do not change
drilling direction when the drill is
Reverse
Forward
Drilling Impact Drilling
37