Philips AVENT SCF394/71 Mode D'emploi page 15

1. Switch off the device.
Battery indicator light description
All lights are Two lights are
steady on. The steady on.
battery is fully
The battery is
charged.
charged
Charged battery sufficiently for
operates maximum two
approximately sessions.*
3 pumping
sessions.*
* One session is the equivalent of 15 minutes (double electric breast pump) or 30 minutes (single
electric breast pump).
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with
milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
2. Insert the adapter
into the power outlet
and insert the small
plug at the other end
into the motor unit.
First light flashes
slowly.
The battery is
charged
sufficiently for
maximum one
session.*
3. The battery is
charging.
First light flashes
quickly.
The battery is very
low, the device will
soon stop
operating,
charging is
needed.
English
4. When the battery is
fully charged, remove
the adapter from the
power outlet and pull
the small plug out of
the motor unit.
Battery lights light
up one by one and
go out all together.
The battery is
charging.
15