KRESS PSX 600 Mode D'emploi page 3

All manuals and user guides at all-guides.com
Kress PSX 600 - GB Seite 7 Montag, 14. Februar 2000 11:47 11
PSX 600
Application
The Pneumatic Drill Hammer can be used universally
for impact drilling, for light chiselling work in masonry
and for drilling as well as screwdriving in wood, metal
and plastic.
Safety Instructions and
1
Accident Prevention
Before putting the machine into operation, read
through these operating instructions completely and
observe the safety instructions contained therein as
well as those in the enclosed booklet on general
safety instructions for electro-tools.
If the mains cable is damaged while working, pull
the mains plug immediately.
Never work with a damaged mains cable.
Wear protective glasses, hearing protection, pro-
tective gloves and sturdy shoes.
For safety reasons, work only with the auxiliary
handle 12 mounted.
Do not work with materials containing asbestos.
Do not carry the machine by the cable.
The mains receptacles in the working area must be
protected by a residual current circuit breaker (RC).
For the attachment of identification markings on the
machine, do not drill into the housing. The protec-
tive insulation would be shorted. Use stickers.
When the drill unexpectedly jams, the machine
kicks back. Therefore, always take a secure stance
and hold the machine firmly with both hands.
2 Illustration
1 Tool holder
2 Dust protection cap
3 Unlocking collar
4 Gear selector/Rotation stop switch
5 Locking button for on/off switch
6 On/Off switch/Speed control
7 Ventilation slots
8 Latch for mains cable module
9 Rotational direction switch
10 Drilling/Impact drilling selector
11 Holder for depth stop
12 Auxiliary handle
13 Adapter for screwdriver bits/drill chuck
Accessories illustrated or described are not
always included as standard delivery items.
3 Technical Data
Pneumatic Drill Hammer PSX 600
Input power 600 W
Output power 300 W
•
Electronic speed control
No-load speed
1st Gear 0-1050 RPM
2nd Gear 0-2250 RPM
Speed under load
1st Gear max. 0-800 RPM
2nd Gear max. 0-1710 RPM
No-load impact rate 5194 per min. max.
Impact energy 2.3 J
•
Right/Left rotation
Clamping collar dia. 43 mm
Euro standard
Tool holder SDS-Plus
Drill dia., max.
Steel 13 mm
Light metal 18 mm
Wood 35 mm
Hammer drilling in conctrete 22 mm
Recommended hammer
drilling range 4-16 mm
Screw dia., max.
Wood 8 mm
Sheet metal 6.3 mm
Weight 2.75 kg
Protection class II /
4 Noise/vibration information
Measured values determined according to
EN 50 144.
Sound pressure level: 84 dB (A)
Sound power level: 97 dB (A)
Workplace related emission value: 87 dB (A).
For operation, noise protection measures are
required.
The typical weighted acceleration is 8.6 m/s
Mounting the Auxiliary Handle and
5
the Mains Cable Module
Before any work on the machine itself, pull the
mains plug!
Operate the machine only with the auxiliary han-
dle 12. Place the auxiliary handle on the clamping
collar and tighten with the clamping screw.
Connect the mains cable module to the handle. The
plug must latch.
English
7
2
.