Kemper 131 00 Consignes De Sécurité Importantes Pour Le Montage page 23

Modification of
3
Factory Setting
1. Remove sign cap (3).
2. Insert hexagonal span-
ner (6mm width across
flats) into the authority
top part (4) and close
valve by turning it to the
right.
3. Now, the temperature,
pre-set at the factory,
can be modified by
maximum half a turn to
the right. 10 notch steps
correspond to 2 K.
4. Check the correct position
of the regulating piston (end
position!) by turning the
shut-off spindle (5) to the left.
© www.kemper-olpe.de – 05.2022 / K410054000001-00 – 23 /88
Note!
After this, the valve has
again to be fully opened
(left turn to end position).
Note!
Do not over-tighten the
end position buffers!