Beninca BOB 30M Livret D'instructions Et Catalogue Des Pieces De Rechange page 17

BOB
• Do not stand in the movement area of the gate.
• Do not let children play with controls and near the gate.
• Should operating faults occur, do not attempt to repair the fault but call a qualified technician.
In the event of a power cut or breakdown, proceed as follows to operate the wings manually (refer to figures
A,B,C):
• Open the protective door of the release mechanism (fig. A).
• Insert the special release key supplied and turn it through 90°, as indicated in fig. B for a right actuator or
as indicated in fig. C for a left actuator.
• It is now possible to open/close the wing manually.
• To restore automatic operation, return the release key to its initial position.
• Remove the release lever and close the protective door.
• Every month check the good operation of the emergency manual release.
• It is mandatory not to carry out extraordinary maintenance or repairs as accidents may be caused.These
operations must be carried out by qualified personnel only.
• The operator is maintenance free but it is necessary to check periodically if the safety devices and the other
components of the automation system work properly. Wear and tear of some components could cause
dangers.
If the product must be dismantled, it must be disposed according to regulations in force regarding the dif-
ferentiated waste disposal and the recycling of components (metals, plastics, electric cables, etc..). For this
operation it is advisable to call your installer or a specialised company.
All Benincá products are covered by insurance policy for any possible damages to objects and persons
caused by construction faults under condition that the entire system be marked CE and only Benincá parts
be used.
Fig.A
S
User's handbook
Safety rules
Manual and emergency manoeuvre
Maintenance
Waste disposal
Warning
Fig.B
L
Fig.C
L
17