Kicker KEY500.1 Manuel D'utilisation page 12

Gain Match: Turn the source unit up to about 3/4
volume or just before the output starts to clip (if the
source unit goes to 30, turn it to 23). Press and hold
the KEY button for 3 seconds until the gain match
LED flashes quickly 3 times. Start the "Key500.1 Gain
Match" track (The amplifier mutes its outputs during
the Setup process so there will be no sound from the
amplifier during setup).
(if the CXARC remote bass has been installed, make
sure it is turned up to maximum output)
1. With the gain knob all the way down, slowly turn
the input gain up (clockwise) until you see the Gain
Match LED light up.
2. Turn it down until the LED no longer flashes.
3. Once the gain has been set, stop the Gain Match
track and quickly press the KEY button to exit Gain
Match Mode.
English
KEY HI PASS
10-40Hz
DC OFFSET
+
−
/
/
OFF ON
BASS
LO PASS BOOST
40-160Hz 0-6dB
L R
INPUT LEVEL
/
GAIN
REMOTE
MATCH
BASS
GAIN
0-11
/
LO HI
12