Breville 800BLXL Mode D'emploi page 13

4. Select the required speed (Blend, Smoothie
or Ice/Auto Pulse) by pressing the
corresponding speed button. The blender will
start to operate and only the selected speed
button will illuminate. The 'Power' button will
continue to flash.
NOTE: Operate the blender only for
the appropriate amount of time
required. The Die Cast
Hemisphere Blender will
automatically stop blending
on the Blend function after
60 seconds (1 minute) and
on the Smoothie and Ice/Auto
Pulse functions to avoid
over processing.
The speed can be changed at any time during
the blending process. Each time a
new speed is selected its button will illuminate
and the previous speed button illumination will
go out.
5. For ice-crushing or ingredients that require
short bursts of power, select the Ice/Auto
Pulse button. The blender will start to operate
and the Ice/Auto Pulse button will illuminate.
The 'Power' button will continue to flash.
12
HOW TO USE THE BREVILLE DIE CAST BLENDER
The pre-programmed functions have been
designed to run for a specific time.
Function Programmed Time
Blend 60 seconds (1 minute)
Smoothie 60 seconds (1 minute)
Ice/ Auto Pulse 60 seconds (1 minute)
NOTE: The smoothie function has a
unique processing technique
that blends the denser
ingredients at a lower speed,
then increases as ingredients
thicken. This may happen
several times while blending
smoothies.
6. To stop blending at any time, press the
selected speed button. The 'Power' button
can also be pressed, but this will also turn the
appliance off and all illuminations will cease.
7. At the end of use, always ensure the Breville
Die Cast Hemisphere Blender is turned off by
pressing the 'Power' button on the control
panel. Then switch the appliance off at the
power outlet and unplug the cord. Ensure the
motor and blades have completely stopped
before attempting to move the appliance, or
when the Breville Die Cast Hemisphere Blender
is not in use and before disassembling,
cleaning and storing.
NOTE: During the blending process,
ingredients may stick to the
sides of the blender jug. To
push the food back onto the
blades, press the 'Power'
button on the control panel
and switch off at the power
outlet and remove the power
cord. Remove the lid and use
a plastic spatula to scrape
down the sides of the jug.
Replace the lid before
recommencing blending.
NOTE: If the blades become stuck,
the blender will automatically
turn off. To reset turn the
blender off at the power outlet,
clean jug with spatula and
then turn back on, blender
will reset.