BS Charger POWER BOX PB-01 Mode D'emploi page 5

1. Connect the smart cable to Power Box. If the « start » and « error » indicatores will alternately flash with
« green » and « red » lights, it proves the circuit normal. If only red light is on, it proves the voltage of Power
Box too low to start vehicle.
2. Correctly connect the smart cable to vehicle's battery terminals: positive (+) to positive (+) = Red clamp,
negative (-) to negative (-) = black clamp.
3. Smart cable will detect the circuit for 3'', if the « start » indicators turns green, and « error » indicators turns
off, then can start the vehicle (the green light will be on 30'', if no start within 30'', the smart cable will
automatically shut down, and the green and red light all will be on at the same time. If want to start vehicle
again, should pull the smart cable out of the Power Box, and plug it into Power Box again).
4. If only red light on, it proves the voltage of the car battery is higher than Power Box, and cannot start the
vehicle.
5. Start the vehicle. After the vehicle started, the « error » indicator will be red flashing and alarm.
6. Remove the smart cable from the vehicle battery terminals, and pull it from the Power Box.
7. If wrongly connect the smart cable to vehicle's battery terminals; positive (+) to negative (-), and negative (-)
to positive (+), then connect the smart cable to Power Box. In this case, the circuit will be shut off
immediately to protect the Power Box and vehicle; meanwhile the « error » indicator will be red flashing, and
the smart cable will alarm.
8. Pull the smart cable out of the Power Box, and remove the clamps from the vehicle battery terminals, then
repeat the right steps.
CHARGING SMARTPHONE OR TABLET INSTRUCTION
• Charge
: Mobile devices (smartphones, tablets, hd action cameras, music players, wireless speakers... )
1. Plug the smartphone cable to USB 5 V - 2.1 A output port.
2. Select appropriate connector for your smartphone or tablet and connect it to any of them. Power Box can
identify and charge the electronic device automatically.
3. The indicators will be on when the device is charging.
Output port: Energy is transferred outwards the product.
Note: The original smartphone cable can also be used if it's USB compatible.
CHARGER FOR 12V VEHICLE PRODUCTS
• Charge
: 12V vehicle products: air compressor, refrigerator...
Output port: 12 V - 10 A. Cable not included.