BS Charger POWER BOX PB-01 Mode D'emploi page 4

JUMP START 12V VEHICLE INSTRUCTION
• Jump start
: Motorcycles, Cars (up to 5L - 5000cc gas engine and 2.5L - 2500cc diesel engine), and Boats...
1. Make sure that the number of indicators is not less than 3.
2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK clamp to the
vehicle's battery negative (-) terminal.
3. Plug the cord of booster cables into the jump start socket.
4. Start the vehicle. The starting attempt should not exceed 4 seconds.
5. When the vehicle is started, remove booster cables from Power Box and disconnect black and red clamps to
the vehicle battery terminals WITHIN 30 SECONDS.
6. Leave the vehicle's engine running.
Power Box can start a vehicle 20 times (depending of the size of the engine and the status of the vehicle battery).
CAUTION : NEVER CONNECT THE RED AND BLACK CLAMPS TOGETHER. DAMAGE, INJURY OR FIRE MAY RESULT.
DO NOT USE THE POWER BOX PORT FOR ANYTHING BUT JUMP STARTING.
• Smart Booster cable :
SMART BOOSTER CABLE INSTRUCTIONS
Smart Clamps features :
- Low voltage protection
- Reverse polarity protection
- Short circuit protection
- Overload protection
- Overcharge and discharge protection
- Temperature control protection