SimplyGo Mini User Manual
Operating the SimplyGo Mini Device
Power Options
Warning: Do not use the device without the battery installed and operating�
•
To run the device on battery power, make sure the battery is properly
inserted and sufficiently charged� (The battery should be fully
charged the first time you use it�)
To run the device using AC power, first make sure you have a
•
battery installed� Then, follow these steps:
1�
Connect the output cable of the AC Power Supply to the
SimplyGo Mini power input connector and plug the power cord
into the device as shown in the "Power Cord Connection" Section
below�
2�
Connect the AC Power Cord's connector into the AC power
supply�
3�
Connect the AC Power Cord's plug into an AC outlet installed to
meet national or regional electrical code�
To run the device using DC power from an automobile or other
•
motorized vehicle, make sure the battery is installed� Start the vehicle
and connect one end of the DC Power Cord to the device's power
inlet and the other end into the vehicle's DC electrical outlet�
SimplyGo Mini Power Cord Connection
When connecting the SimplyGo Mini device to either an AC or DC power
supply:
1�
Plug the desired power supply source (AC or DC) cord into the power
inlet�
2�
Connect the pronged end of the power cord into an electrical
outlet as shown in the illustration above�
14
1
2
2
1