Publicité
Les langues disponibles
Les langues disponibles
• Do not disassemble charger; take it to an authorized service center
when service or repair is required. Incorrect reassembly may result
in a risk of electric shock, electrocution or fire.
• To reduce risk of electric shock, unplug charger from outlet before
attempting any cleaning. Removing the battery pack will not reduce
this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical
power (120 Volts AC). Do not attempt to use it on any other voltage!
This does not apply to vehicular charger.
Chargers
Your battery can be charged in D
WALT 1 Hour Chargers, 15 Minute
E
Chargers or Vehicular 12 volt charger. Be sure to read all safety
instructions before using your charger.
Consult chart on back cover for compatibility of chargers and battery
packs.
Charging Procedure
1 HOUR CHARGERS
1. Plug the charger into an appropriate power outlet.
2. Insert the battery pack into the charger, as shown in FIG.2, making
sure the pack is fully seated in the charger. The red (charging) light
will blink continuously indicating that the charging process has
started.
15 MINUTE CHARGER
FIG. 2
All manuals and user guides at all-guides.com
1 HOUR CHARGERS
5
3. The battery pack will be fully charged in about 1 hour. The
completion of charge will be indicated by the red light remaining ON
continuously. The pack is fully charged and may be used at this time
or left in the charger.
TROUBLE INDICATORS: These chargers are designed to detect
certain problems that can arise with battery packs which would be
indicated by the red light flashing at a fast rate (and continuous beeping
for 15 Minute Chargers). If this occurs, re-insert battery pack. If
problem persists, try a different battery pack to determine if the charger
is OK. If the new pack charges correctly, then the original pack is
defective and should be returned to a service center for recycling. If the
new battery pack elicits the same trouble indication as the original,
have charger tested at an authorized service center.
PROBLEM POWER LINE
If your charger has a Problem Power Line indicator: When the charger
'is used with some portable power sources such as generators or
sources that convert DC to AC, the charger may temporarily suspend
operation, flashing the red light with two fast blinks followed by a
pause. This indicates the power source is out of limits.
HOT PACK DELAY
If your charger has a Hot Pack Delay feature: When the charger detects
a battery that is hot, it automatically starts a Hot Pack Delay, suspending
charging until the battery has cooled. After the battery has cooled, the
charger automatically switches to the Pack Charging mode. This
feature ensures maximum battery life. The red light flashes long, then
short while in the Hot Pack Delay mode.
15 MINUTE CHARGERS
1. Plug the charger into an appropriate power outlet. The charger will
beep twice, the red light will blink and go off.
2. Insert the battery pack into the charger, as shown in FIG. 2, making
sure the pack is fully seated in the charger. The red light will blink
and the charger will beep once indicating the charging process has
started.
Publicité
