Interior Lining - SCHUBERTH S1 Pro Mode D'emploi

D. THE HELMET
Fitting the sun visor
1. Position the sun visor holders on the helmet (on the left with the
sun visor slide) so that you can see the mounting sockets for the
sun visor.
2. Carefully insert one end of the sun visor (with snap connector) into
the corresponding mounting socket of the helmet, then push with
appropriate pressure so that you feel and hear it snap in place.
Repeat this with the other side.
3. Retract the sun visor between helmet outer and inner shell and
lower it with the operating slide.
4. Check that sun visor mechanism is operating correctly.
Tip:
The sun visor was developed so that it can
also be fi tted with the straight edge at the
bottom. Since one person's vision differs
from another, this adaption can be more
practical and comfortable for your own
sense of vision.
Tip:
To suit the respective light conditions, a lighter version of the
sun visor with 60% brown tint is available as an optional extra in
addition to the standard visor with 80% grey tint.
78

11. INTERIOR LINING

The two-colour, exchangeable interior lining of the S1 PRO guarantees
both an excellent fi t (through the MaxFit
better ventilation. The headband padding ensures that the helmet fi ts
comfortably all around the head; there are three colour contrasted
head pads for cushioning the head that leave the ventilation ducts
uncovered (see also section D.12. "Ventilation systems – head
ventilation"). Head pads and headbands of varying thickness allow
individual adjustment within one helmet size.
The interior lining is made with materials that are kind to the skin
(especially where it comes into direct contact with the head). The
principal material used is a soft, breathable Coolmax
good warmth and moisture-transporting properties. The head pads are
made from a special anti-bacterial, perspiration-absorbing material.
Removing and fi tting
Headband and pads are fi xed to the inner shell with Velcro and can
be removed by careful pulling. Make sure the headband is positioned
centrally when re-fi tting it. To help you with this, the headband is
identifi ed with two small notches and the inner shell with two protruding
lines at the centre positions at front and back.
® interior concept) and
®
fabric with very
79