Interior Lining; Fastener System; Storing The Helmet - SCHUBERTH S1 Pro Mode D'emploi

H. MAINTENANCE AND CARE

3. INTERIOR LINING

Replaceable parts of the interior lining
The head pads and headband can be washed by hand using mild soapy
water (e.g. any very diluted, normal mild detergent) at a maximum of
30 °C. Allow the damp interior lining to dry at room temperature and
with good ventilation.
Tip:
If required (e.g. during a break in a journey), the headband can
be hung out to dry over the mirror.
Non-replaceable parts of the interior lining
Use a mild, lukewarm soap solution (e.g. any very diluted, normal mild
detergent can be used) to clean the interior lining.
Carefully apply the soap solution with a damp sponge or cloth by
dabbing or gentle rubbing. The inner padding should not be soaked
with water. Remove the soap solution from the padding by pressing a
dry, absorbent cloth on it. Repeat this process with clear water.
Afterwards, allow the interior padding to dry in a well-ventilated place.
TechSkin
It is best to clean the TechSkin comfort material with high-quality
leather-like surface structure regularly with a soft, moistened cloth.
94

4. FASTENER SYSTEM

Double D-ring fastener
The double D-ring fastener is maintenance-free.
Caution:
Do not apply oil or grease to the metal parts.

5. STORING THE HELMET

When not in use, keep the helmet in the supplied helmet bag in a dry,
safe place. For better ventilation and protection of the anti-fog coating,
make sure the visor is not fully closed, but is locked in at least the
second locking position above the town-riding position. Always store
the helmet so that there is no risk of it falling onto the fl oor. Damage
caused this way is not covered by the guarantee.
Note:
Store the helmet out of reach of children and animals.
95