Roco geoLINE Mode D'emploi page 15

Fig. 13
In principle, attention must be paid that the setting of the points must correspond to the drive direction,
in the case of polarized points, because otherwise a short circuit can occur in the area of the cross frog
when the points are run through.
It is recommended not to polarize the cross frog if it is not guaranteed that a set of points always takes
the correct points setting to the passage.
The geoLINE points in digital operation
The points actuator must be equipped with a points decoder (Art. 61196), in order to bring a set of geoLI-
NE points into operation digitally. All geoLINE points are designed so that the installation of a decoder is
possible without additional cabling.
Fig. 14
Decoder
Fig. 15
Colour coding
Terminal lug
The connection plug for polarizing is removed from
its parking position and plugged into the socket at
the end of the electrical drive, in order to polarize
the cross frog. Attention must be paid here that the
colours of the cable agree with the colours of the
colour coding positioned above the socket (Fig. 13).
The five-terminal connector of the points decoder is
plugged into the free socket of the socket strip next
to the polarizing plug. The polarizing plug must not
be removed during this, because the supply of po-
wer for the points decoder takes place through it.
The points decoder is attached with the screw asso-
ciated with it after it has been positioned.
The cross frog will have been polarized in this type
of connection.
The screw serving to attach the cross frog must be
loosened and the connection contact for polari-
zing must be pulled out, in order to depolarize the
points.
The terminal lug can be pushed onto the plastic peg
to keep it safe (Fig. 15).
The screw of the cross frog must, of course, be re-
tightened afterwards.
GB
15