Publicité
Les langues disponibles
Les langues disponibles
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural
members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC.
manufacturer changes; however, it is ultimately the responsibility of the installer to prevent damage due to
14.
Drill pilot hole in truck bed per measurements. With hole saw or knockout punch in large hole to 3-1/4".
Plastic bed liner will need to be removed before drilling or punching out. Bed liner will need to be cut as noted
in general instruction #3 on page 5. Optional: Spray under coating around 3-1/4" holes to prevent rusting.
15.
Loosely reattach rails to frame bracket.
16.
From truck bed attach pucks and trim rings to rails
head screw and lock washer. Tighten to 100ft.lbs. torque.
Figure 22
5/8" FLAT WASHER
4 PLACES
17.
Insert puck plugs (as shown) whenever pucks are not in use.
Install REESE
18.
19.
Torque hitch assembly bolts per hitch instructions.
20.
Torque all 5/8" rail kit hex bolts to 170ft.lbs and 3/4" hex bolts to 260ft.lbs
21.
Replace any brake lines and spare tire that may have been removed/relocated.
30868N – 9FEB11D
5/8" BUTTON HEAD
4 PLACES
5/8" LOCK WASHER
4 PLACES
PUCK
4 PLACES
TRIM RING
4 PLACES
Elite
Series
fifth wheel per hitch assembly instructions.
PCN14805
CAUTION:
does its best to communicate tow vehicle
installation.
(Figure
22) using 5/8" flat washer under the puck, button
DO NOT lubricate threads. It may cause bolt failure.
Truck Bed
Puck Plug
Puck Assembly
(Figure
©2011 CEQUENT PERFORMANCE PRODUCTS, INC.
WARNING:
23)
Figure 23
LITHO IN USA
10
Publicité
