Grillo PK 1000 Emploi Et Entretien page 9

IDENTIFICATION
The vehicle's serial number is punched on the nameplate on the right-hand longitudinal member of
the chassis and on the gearbox nameplate.
SPARE PARTS
We recommended using only original GRILLO spare parts.
PUTTING THE MACHINE INTO SERVICE
1) Make sure the machine is complete and that it has not suffered any damage during transit.
2) Check the levels of the engine oil, the gearbox oil and the radiator liquid.
3) Check the tyre pressures:
10,0 / 75 – 15,3 10PR (5,3 bar)
10,0 / 80 – 12
26 x 12.00 / 12
4) Check the battery voltage, it must not be less than 12 Volts; recharge if necessary.
If a dry battery has been supplied with separate acid, to put the machine into service proceed
as follows:
1) Pour in the acid and wait 2 hours;
2) Charge the battery with a charger set to 12 Volts on a slow charge for 2 hours.
Caution, if this procedure is not observed this could lead to the battery deteriorating and the
acid leaking out during work.
IMPORTANT!!! When fitting the battery be careful not to reverse the poles. Do not start the
engine if the battery is disconnected.
BATTERY – CAUTION!
The gas released by the battery is explosive, so keep it away from naked flames or sparks. Check
the level of the liquid at regular intervals and keep the terminals greased with Vaseline.
RUNNING - IN
During the running-in period (first 70 operating hours), do not work with the engine at high throttle,
taking care not to use more than about 70% of the power available.
After the first 20 operating hours and at the end of the running-in period:
Check the tightness of all the fasteners and connections (screws, nuts and unions).
Check all the units, engine, gearbox and pipelines for oil leaks.
Adjust the handbrake.
Refer to the engine handbook for the specific running-in instructions.
6PR (2,6 bar)
8PR (2,7 bar)
7