Grillo PK 1000 Emploi Et Entretien page 10

INSTRUCTIONS FOR USE
DESCRIPTION OF THE CONTROLS (Fig. 1 - Fig. 2)
1) Clutch pedal (Fig. 2 n° 1): disengages the engine from the transmission. It must be operated
whenever various control levers (gearbox, high – low range lever, PTO control lever) are used,
before stopping the machine and before starting the engine.
2) Brake pedal (Fig. 2 n° 2):
3) Throttle pedal (Fig. 2 n° 3).
4) Parking brake lever (Fig. 1 n° 4): acts simultaneously on the brakes of the rear wheels. The
brake is engage by pulling the lever up; to release, press the button on the end of the lever and
lower it.
5) Gear lever (Fig. 1 n° 5):
and two reverse speed.
6) High-low range lever (Fig. 1 n° 6):
speed.
7) Differential lock lever (Fig. 1 n° 7): pull up to operate.
8) Front axle disengage lever (Fig. 1 n° 8): move forward to release the axle, back to engage. It
may happen that the engage and disengage of the front axle lever is difficult. Do not force the
lever, but move the machine a few cm forward and backward and try again.
9) Dumper control lever (Fig. 1 n° 9).
DESCRIPTION OF THE CONTROLS – Fig. 3
1) Generator warning light (red).
2) Engine oil low pressure warning light (red).
3) Air filter blockage warning light.
4) 4-wheel drive engaged indicator light.
5) Dipped headlight indicator (green).
6) Glow plug preheating indicator.
7) Direction indicator warning light (green).
8) Emergency light switch.
9) Key-switch for switch-on, enabling services, igniting and stopping engine.
10) Direction indicator, horn switch and lights switch.
11) Cooling water temperature indicator.
12) Hour-counter.
13) Rev. Counter.
14) Fuel level indicator.
15) Fuel reserve.
16) Parking lights warning light.
17) Parking brake warning light.
18) Engine oil temperature earning light.
19) Headlights warning light.
operates the brakes on the wheels.
in combination with the high – low range lever, this provides eight forward
push forward for high range gears; pull back for a low range
8