Publicité
Les langues disponibles
Les langues disponibles
Programming the turnout decoder
The turnout decoder must be placed in the programming mode before you can program the decoder.
To do this, quickly switch the turnout drive back and forth manually five times in a row. The turnout
decoder is now in the programming mode and indicates this by switching back and forth one time per
second. After switching 30 times, the turnout decoder exits the programming mode.
When programming the address, the turnout decoder immediately exits the programming mode upon
confirmation of the address. When programming the CV's, the turnout decoder exits the programming
mode once it has switched 30 times. To exit the programming mode earlier, program CV 80 to '0'.
Note: The CV values cannot be read out.
Programming of the address with the Z21
1.
Create the new switch track in your control centre.
2.
Switch into control centre mode
3.
Ensure that the switch track decoder is in programming mode.
4.
Confirm the respective switch track in the control centre.
5.
The switch track decoder is now programmed on this address and can be switched by pressing the
switch track symbol in the control centre.
Programming the address using the MULTIMAUS
1.
Switch to the turnout mode on the MULTIMAUS
2.
Place the turnout decoder in the programming mode.
3.
Enter the desired turnout address on the MULTIMAUS
4.
Confirm your input using the arrow keys.
5.
The turnout decoder is now programmed to this address and can be switched with the MULTI-
MAUS
in the turnout mode using the arrow keys.
®
Programming the address using the routeControl
1.
Place the turnout decoder in the programming mode.
2.
Enter the desired turnout address using the number keys.
3.
Confirm your input using the turnout switching keys.
4.
The turnout decoder is now programmed to this address and can be switched with the RouteControl.
Programming the address in Rocomotion
1.
Place the turnout decoder in the programming mode.
2.
Add a turnout to the track diagram in the switchboard and define an address.
3.
Switch the turnout in Rocomotion.
4.
The turnout decoder is now programmed to this address and can be switched in Rocomotion.
8051250920.indd 15
®
.
®
using the function keys.
®
GB
15
05.02.2018 10:53:31
Publicité
