Publicité
Les langues disponibles
Les langues disponibles
Installation of the electrical drive 61195
The points actuator is placed into the bed of the points and attached with screws. The setting catch for
manual operation must be installed in accordance with the respective installation place. The setting
catch can be pulled out and pushed in again at the opposite side of the setting lever if necessary.
8051250920.indd 13
The electrical actuator has a double coil system
with a limit stop switch. The limit stop of the points
actuator prevents the presence of any voltage at
the respective coil after the setting procedure has
been completed, thus avoiding damage.
Delivery status / low voltage: ON
medium voltage
high voltage: OFF
GB
Optional
13
05.02.2018 10:53:31
Publicité
