marklin Ae 6/6 Serie Mode D'emploi page 6

Function
• Possible operating systems:
6646/6647 Märklin Transformer, Märklin Delta, Märklin
Digital, Märklin Systems.
• Recognition of the mode of operation: automatic.
• Addresses that can be set (Control Unit): 01 – 80.
Address set at the factory: 66
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: AE 610 492-1
• Headlights change over with the direction of travel.
• Headlights with „Swiss headlight changeover".
• Adjustable acceleration (ABV).
• Adjustable Braking delay (ABV).
• Adjustable maximum speed.
• Volume can be changed for the sound effects
• Setting the locomotive parameters electronically with
the Control Unit, Mobile Station or Central Station.
The maintenance work necessary with normal
operation of this locomotive is described below.
Please see your authorized Märklin dealer for
repairs or spare parts
6
Safety Warnings
• This locomotive is to be used only with an operat-
ing system designed for it (Märklin 6646/6647 AC
trans-former, Märklin Delta, Märklin Digital or Märklin
Systems). Under no circumstances should transform-
ers rated for an input of 220 volts be connected to the
American 110 volt household current system.
• This locomotive must never be supplied with power
from more than one transformer.
• The feeder track must be equipped to prevent interfer-
ence with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for
this purpose. The interference suppression set is not
suitable for digital operation.
• Pay close attention to the safety warnings in the
instructions for your operating system.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Märklin have
been installed in Märklin products or where Märklin products have
been converted in such a way that the non-Märklin parts or the
conversion were causal to the defects and / or damage arising.
The burden of presenting evidence and the burden of proof thereof,
that the installation of non-Märklin parts or the conversion in or of
Märklin products was not causal to the defects and / or damage
arising, is borne by the person and / or company responsible for
the installation and / or conversion, or by the customer.