Transportation And Storage; On Site Transport; Road Transport; Long Term Storage - PACLITE Equipment TR-600 Manuel De L'opérateur

Masquer les pouces Voir aussi pour TR-600:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Transportation and Storage

Lifting
Where it is necessary to use lifting equipment to position the rammer, check and confirm that the
rubber isolators on the operation handle is not damaged or cracked. If they are cracked or damaged,
replace the rubber isolators before attempting to lift the machine. Also make sure that the lifting
equipment has a WLL (Working Load Limit) suitable for the rammer's weight (See specification chart
on page 5 or the machine number plate). Attach suitable chains or slings ONLY to the lifting point on
top of the rammer's operating handle.
NEVER leave the engine running whilst transporting or moving the TR Rammer, even if it is only a
short distance.
The height of the operating handle can be adjusted within the range of 850 ~ 880 mm. Loosen
three bolts at each side of the operating handles base, and retighten them at the desired handle
height. Note that when the handle is set too high, excessive vibration may be transmitted through
the handle.

On Site Transport

The rammer may be moved vertically by 2 people, or laid only on the Transport Rollers.

Road Transport

The rammer must be transported as far as possible standing up, strapped to the body side board of
the truck, or strapped inside a lorry (panel truck). If not possible, it may be laid down (engine facing
upwards, not on its sides) only on the Transport Rollers, in a stable position and strongly strapped
down to guard against rolling or sliding.
Wait until the unit is completely cool before laying it down.
CAUTION
Long-term Storage
The chemical composition of the fuel will deteriorate after prolonged storage. When the machine
needs to be stored for a long time, remove all the fuel from the fuel tank. You can achieve this by
running the engine with the fuel tap being closed (see picture). Also remove the fuel from the drain
plug.
Clean up oil and dust accumulation on rubber parts.
Clean the base plate and apply a light coating of oil to prevent rust formation.
Cover the machine and store in a dry place.
Gasoline Rammer Manual (2009 version)
11

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Tr-670Tr-740

Table des Matières