Operation - Omcan WO-IT-0435-S Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

have remained with only the coal and turn the valve in a horizontal position to stabilize the oven and start
cooking.
Once you have finished cooking, we recommend you to leave the two doors closed while the oven is
cooling. This is to avoid the change between internal and external temperatures creating condensation.
WARNING: Continuously putting wood into the combustion chamber causes an increase of
temperature, if the increase is too much it can cause the deformation of the oven (damage not covered
under the warranty), NEVER EXCEED THE TEMPERATURE INDICATED ON THE OVEN THERMOMETER
250/300°C - 482/572°F.
USE OF THE OVEN
Start-Up
Before using the oven:
Carefully follow all the instructions.
Always use oven gloves to avoid burns.
Before each use, make sure that there are no foreign objects inside the plate-warmer compartment or in
the combustion chamber.
Operation Descriptions
Put the wood into the combustion chamber and light the fire using suitable products (lighters).
During the lighting keep open the air vents located on the door of the combustion chamber.
To heat the oven use dry wood of small size until reaching the maximum temperature of about 250/300°C -
482/572°F. When the oven has reached the desired temperature close the vents.
Small quantities of wood should be feed to avoid a sudden increase of temperature.
Be careful not to exceed the temperature shown on the thermometer of 250/300°C - 482/572°F.
To increase the temperature just put a very small quantity of wood in the combustion chamber, to lower the
temperature just open the door to the cooking chamber.
It is possible to cook the food directly above the refractory floor (only for foods such as bread and pizza).
For baking of bread and cakes we recommend to bring the oven initially to the desired temperature (see
the table about the recommended temperatures), then make sure that in the combustion chamber there
is only embers then close the valve of the chamber (turn it in horizontal position). After the closure of the
valve wait for about 15-20 minutes, so that the temperature of the cooking chamber is harmonious and
stabilized. Put the bread or the pizza above the refractory floor and wait for the product to cook. After the
bread has been baked it is possible to bake pastries (cakes, pies etc.), without rekindling the fire.
For baking of bread we recommend to place the loaf of bread on a distance of 10 cm from the perimeter
wall of the cooking chamber.
COOKING TIME
Below are some general guidelines for cooking some kinds of dishes. Do some tests, by cooking small portions
to verify the real cooking time and the right temperature. Please note that the temperatures refers to the oven
thermometer.
8

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wo-it-0435-mWo-it-0620-l436484364943650

Table des Matières