Troubleshooting Guide - Technics SL-1500C Manuel D'utilisation

Troubleshooting guide

Before requesting service, make the below checks. If you are in doubt about some of the check
points, or if the remedies indicated in the chart do not solve the problem, contact your dealer.
No power.
 Is the AC power supply cord plugged in?
Plug the AC power supply cord in firmly. (  12)
There is power but no sound, sound is weak or abnormal, loud and with
distorted sound quality.
 Are device connections and PHONO or external output terminal connections correct?
Connect the PHONO output terminals with the amplifier's PHONO input terminals. (  13)
Connect the external output terminals to the amplifier's external input terminals. (  12)
 Is the external output switch correctly set?
When connecting the external output terminals, set the external output switch to "ON". (  12)
Left and right sounds are reversed.
 Are the stereo connection cable connections to the amplifier or receiver reversed?
Double check all connections. (  12, 13)
 Are connections of the head shell's lead wires to the cartridge terminals correct?
Double check all connections. (  21)
Low, continuous sound (humming or buzzing sound), noise or popping sound
is heard during play.
 Are there other appliances or their AC power supply cord near the stereo connection cable?
Separate the appliances and their AC power supply cord from this unit.
 Is the earth lead connected?
When connecting the PHONO output terminals, correctly connect the PHONO earth lead. (  13)
 Are both the PHONO terminal output and external output terminals simultaneously connected to
the connected device?
Connect one or the other. (  12, 13)
The indicator on the speed select button [33] or [45] blinks.
Perform the following operations when the indicator on the speed select button [33] or [45] blinks.
The symptom may be improved.

Press [ ] to OFF.

Pull out the power plug, wait for three seconds or more, and then insert the plug again.

Press [ ] to turn the unit on and press [START-STOP] to rotate the turntable.
 If the indicator on the speed select button blinks again, check which one is blinking and contact our
service representative.
22
(22)
English