Technics SL-1500C Manuel D'utilisation page 19

3
Lift the cue lever and move the
tone arm over the record.
Cue lever
4
Lower the cue lever slowly.
The tone arm moves down slowly.


To temporarily stop play
Lift the cue lever.
 The stylus lifts off the record.
 To start play again, lower the cue lever.


When play finishes

After lifting the cue lever to return the tone
arm to the arm rest, lower it completely.

Press [START-STOP].
The electronic brake gently stops the
turntable.

Press [ ] to turn the unit off.

Clamp the tone arm with the arm clamp.

Put the stylus cover back on (to protect the
stylus tip).
Play starts.


Auto lift-up function
This function automatically lifts up the tone arm
after a record finishes playing. It prevents the
last groove from playing back repeatedly.
(It does not stop the turntable rotation.)
This function requires the following setting to
become active.
Setting: With the unit turned off, set the auto
lift-up switch on the rear side to "ON".
 After an auto lift-up, be sure to perform the
 
steps to described above in "When play
finishes".
Attention
 Depending on the record, it may take some
time after the play finishes for the auto lift-
up to operate, or it may operate while the
record is still playing. If the tone arm is lifted
during play, set the auto lift-up switch to
"OFF".
 The auto lift-up function may not operate
normally. For the auto lift-up function to
operate normally, the cue lever must be
completely lowered after the tone arm is
returned to the arm rest following the end of
play.
 
When playing EP records
 Press the speed select button [45] ([45]
lights).
 Fit the EP record adaptor over the center
spindle.


When playing SP (78 rpm) records
 Press the speed select buttons [33] and [45]
at the same time (78 rpm: [33] and [45]
light).
 
When using a record stabilizer
(not included)
 See the instruction manual of the record
stabilizer.
 Maximum weight: 1 k g
Auto lift-up
switch
19
(19)
English