Display Assembly Wall Mount Instructions - Health O Meter 349KLX Instructions De L'utilisateur

DISPLAY ASSEMBLY WALL MOUNT INSTRUCTIONS

Required Parts
(1) Display assembly
(2) #8 Anchoring screws (4.2 mm nominal OD)
(2) Mounting anchors, compatible with wall construction
Caution: When wall mounting the display assembly, ensure that the mounting location is
free of electrical lines, gas pipes, and other safety hazards. Ensure that wall is of
construction that can support the display assembly.
Note:
Remote head can be mounted to a wall up to 6 feet (1.83 m) from the base or it can be
mounted on the display bracket (included) for placement on a table up to 6 feet (1.83 m) from
the base.
1.
Position the display assembly
on the wall, and carefully trace
around the display.
2. Mark a level horizontal line,
3/4" (19 mm) below the top of
the display outline.
3. Mark a vertical line 1-3/8" (35
mm) from each side of the
display outline.
4. At the horizontal and vertical
intersection, carefully drill the
appropriate size holes.
1-3/8"
(35mm)
Marked
Drill Holes
8
¾" (19mm)