Water Softening System / Special Salt - Thermador DWHD771W Serie Mode D'emploi

Water softening system / special salt *

To ensure good rinsing results, the dishwasher requires
soft water, i.e. water which is low in lime, otherwise
limescale will be deposited on the utensils and interior
container. Tap water above 7° dH (1.2 mmol/l) must be
softened. The water is softened with special salt
(regeneration salt) in the water softening system
Adjusting the water softener settings
Using the test strip included with your
dishwasher
(Purchased test strips may have a differ-
ent scale)
Adjusting the water softening system
The amount of salt dispensed can be set from
: . Salt is not required at the set value
• ‹ˆ
Set the softening system as follows:
Ask your local water utility company for the water
1.
hardness value of the tap water.
Required setting can be found in the water hardness
2.
table.
Open the door.
3.
Press the ON/OFF button
4.
Press the Setup button for 3 seconds until
5.
shown on the display window
Make the selection with setting buttons + -
6.
Press and hold the Setup button for 3 seconds.
7.
The chosen setting has now been stored.
Water soft-
ener setting
:
• ‹‹
:
• ‹‚
:
• ‹ƒ
:
• ‹„
• : ‹...
:
• ‹†
:
• ‹‡
:
• ‹ˆ
• : ‹‹
: .
• ‹‹
.
(
: is
• ‹‹
.
H
.
P
of the dishwasher. The setting and therefore the required
amount of salt depends on the degree of hardness of
your tap water (see following water hardness table).
* optional feature which may or may not be included with
your dishwasher.
Add salt to salt
dispenser
°E value
No 0-8
Yes 9-10
Yes 11-12
Yes 13-15
Yes 16-20
Yes 21-26
Yes 27-38
Yes 39-62
Using special salt
to As soon as the low salt indicator
digital display, salt should be topped off. Refilling the salt
dispenser should be done before switching on the
appliance. This ensures that extra salt water is washed
out and will not corrode the rinsing tank.
NOTICE: Detergent will destroy the water softening
system! Never pour detergent into the salt dispenser.
Top off the salt as follows:
Undo the screw plug on the dispenser
1.
Fill the dispenser with water (required only when
2.
switching on the appliance for the first time).
Add salt as illustrated (do not use table salt or
3.
tablets).
The water is displaced and runs out.
For more information about buying dishwasher salt,
please contact Customer Service 1-800-944-2904.
Water hardness
mmol/l
0-1.1
1.2-1.4
1.5-1.8
1.9-2.1
2.2-2.9
3.0-3.7
3.8-5.4
5.5-8.9
@ lights up on the
1R .
13