Operation - Amana AP148D Mode D'emploi

Operation

Control Panel
Power Control
The power control turns the unit on and off.
Warning Light
Condensed water may accumulate in the unit.
If the internal tank becomes full, the Warning
Light will shine and the unit will not operate until
it has been drained.
Mode Control
The mode control has 3 settings:
• Cool • Dehumidify • Fan
Cooling Mode
When cool mode is selected, " " will show in
the LCD display. During the cooling mode the
air is cooled and hot air is exhausted to the
outside through the exhaust tube. Adjust fan
speed and air temperature to suit your desired
comfort level.
Note: The air exhaust hoses must vent
outside the room when using cool
mode.
Dehumidify Mode
When Dehumidify mode is selected, " " will
show in the LCD display. Air is dehumidified
as it passes through the unit, without being
in full cooling mode. If room temperature is
higher than 77˚C, fan speed can be adjusted;
otherwise fan speed is fixed to "Low".
Note: If the unit is to be used as a dehumidi-
fierm do not connect the exhaust hose
let the warm air return to the room.
Continuous drainage is then necessary.
Fan Mode
When fan mode is selected, " ", " " or " "
will be shown in the LCD display. Air is
circulated throughout the room with no
cooling.
Note: Unit does not need to be vented in Fan
mode.
Fan Speed Control
The Fan Speed Control has 3 settings: High,
Medium and Low.
Timer
Auto Turn Off:
With machine in running mode, press timer
button for setting timer control. Press "+" or
"–" to select number of hours you would like
the unit to run before it automatically shuts off.
Auto Turn On:
With machine in stand by mode, press timer
button for setting timer control. Press "+" or
"–" to select number of hours before the unit
automatically starts running in air conditioning
mode.
Note: The time is adjustable between 1-24
hours.
Temperature Controls
• Used for adjusting the thermostat.
• The default display is room temperature.
• In cooling mode, when "+" or "–" button
is pressed, the set temperature is displayed
and may be adjusted. After 15 seconds the
display will revert back to room temperature.
Temperature is only adjustable in cool mode.
Note: By pressing both "+" / "–" buttons at
the same time for more than 3 seconds,
the display will toggle between Celsius
and Fahrenheit.
English
(7)