Accessories - DeVilbiss TEKNA PROLITE 703536 Fiche Technique

TB-1014-B
Troubleshooting Possible Problems in Operation
CONDITION
Runs and sags
Thin, sandy coarse finish drying
before it flows out
Thick, dimpled finish
"orange peel"

Accessories

HAV-555 HAV-500 OR
DeVilbiss
Air Adjusting Valve Adjusting Valve
with Gauge (HAV-512 SHOWN)
HAV-500 does not
have pressure gauge.
Use to precisely set
Use to control air
air pressure to gun.
usage at gun.
703625
HV40 Air Cap Test Kit
The purpose of this test
kit is to measure air cap
atomizing air pressure at
the center air port of the air
cap. Used to confirm code
compliance and as a daily
quality control measure.
Automotive Refinish Quick Connects
For HVLP Guns (Air)
High Flow Type.
HC-4419 Stem
HC-4719 Coupler
1/4" NPT(F)
1/4" NPT(M) /NPS(M)
HC-1166 Stem
HC-4720 Coupler
1/4" NPT(M)
14
CAUSE
Too much material flow.
Material too thin.
Gun tilted on an angle, or gun motion
too slow.
Gun too far from surface.
Too much air pressure.
Improper thinner being used.
Gun too close to surface.
Too much material coarsely atomized.
Air pressure too low.
Improper thinner being used.
Material not properly mixed.
Surface rough, oily, dirty.
192212 Professional
Spray Gun
HAV-512
Cleaning Kit
Contains six preci-
sion tools designed
to effectively clean
all DeVilbiss, Binks,
Finishline and other
brand spray guns.
40-128
Twin Cartridge,
Paint Spray
Respirator
NIOSH-Certified
(TC84A-1623) for respira-
tory protection in atmos-
pheres not immediately
dangerous to life.
HAF-507 Whirlwind™
In-Line Air Filter
Removes water, oil,
and debris from the
air line.
1/4" NPT(F)
(cont'd)
CORRECTION
Adjust gun or reduce fluid flow.
Mix properly or apply light coats.
Hold gun at right angle to work and adapt to proper
gun technique.
Check distance. Normally approximately 6–8".
Reduce air pressure and check spray pattern.
Follow paint manufacturer's mixing instructions.
Check distance. Normally approximately 6–8".
Follow paint manufacturer's mixing instructions.
Increase air pressure or reduce fluid flow.
Follow paint manufacturer's mixing instructions.
Follow paint manufacturer's mixing instructions.
Properly clean and prepare.
JGA-156-K10 192218 Scrubs
Spring Clips
Hand Cleaner Towels
Joins any single
p i e c e D e V i l b i s s
air cap with latest
version MBC-368,
S c r u b s
M S A - 1 o r G T I -
moistened hand cleaner
3 retaining rings.
towel for painters, body
Helps prevent parts
men and mechanics that
loss and provides
go where you go and no
easier assembly.
water is needed.
702740 TEKNA Wrench
14 mm
For maintenance use.
Spray Gun Lube
®
SSL-10 (2 oz. bottle)
Compatible with
all paint materi-
® a r e a p r e -
als; contains no
silicone or petro-
leum distillates to
contaminate paint.
MSDS Sheet avail-
able upon request.
10 mm