Chart 1 - Air Caps; Chart 2 - Fluid Nozzles & Fluid Needles - DeVilbiss TEKNA PROLITE 703536 Fiche Technique

Parts Replacement/Maintenance
Chart 1 – Air Caps
ORDER NO. FOR TECHNOLOGY
AIR CAP
703621 HVLP
703539 High Efficiency
703626 High Efficiency
NOTE 1: Guns with HVLP caps must not exceed 0.7 bar (10 psi) air cap pressure with
gun fully triggered. (Aproximately 17 psi gun inlet pressure.) (See accessories
for air cap test kit which is available to set the exact cap pressure.)
When used with high efficiency caps and Automotive Refinishing materials,
these spray guns have been found to exceed 65% transfer efficiency under
recommended conditions.
NOTE 2: When removing air cap from retaining ring, don't remove slip ring (2)
or retaining ring seal (5) from retaining ring. Damage to the parts may
occur. Slip ring and retaining ring seal are not available as replacements.
Simply wipe parts clean and reassemble with new or clean air cap.
Chart 2 – Fluid Nozzles & Fluid Needles
ORDER NO. FOR PART NO. ON
FLUID NOZZLE FLUID NOZZLE
703627 PRO-205-10
703628 PRO-205-12
703622 PRO-205-14
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time.
Lightly lubricate the threads of the fluid nozzle before reassembling. Torque
to 18–20 Nm (13–15 ft-lbs). Don't over tighten the fluid nozzle. Use 10 mm
wrench supplied with gun.
MARKING NOMINAL
ON AIR CAP OPERATING GUN
INLET PRESSURE
BAR/PSI
HV40 (1.2) / 17
(for compliance)
TE20 (1.8 – 3.5) / 26 – 50
TE40 (2.0 – 3.5) / 29 – 50
PART NO. ON ORDER NO. FOR
FLUID NEEDLE FLUID NEEDLE
PRO-320-085-10 703629
PRO-320-12-14 703623
AIR FLOW
LPM/SCFM
(298) / 10.5
(340 – 550) / 12 – 19.4
(368 – 550) / 13 – 19.4
TB-1014-B
11