Kobalt SGY-TANK3 Mode D'emploi page 9

OPERATING INSTRUCTIONS
B. Independently with Low-Consumption Air Tool
NOTE: This air tank may be used with a
low-consumption air tool (not included) when a
compressor cannot be used. Connect the plug end of
air hose (not included to 1/4-in. quick-connect
coupler (H). Connect coupler end of air hose to air tool
(See Figure 9).
NOTE: Depending on the requirements of the tool, it
may be necessary to add an in-line air regulator
(not included) to control the air pressure between the air
tank and the tool. Do not exceed the maximum PSI
recommended by the tool manufacturer.
C. Accumulator: Adding Additional Air Capacity to Existing Compressor
NOTE: This air tank can be used as an air accumulator
to provide consistent pressure to air tools and to extend
the work area. See figure 10 (air compressor and
hoses not included).
9
10
Air tool /
work area
9
Compressor
Air tank