Kobalt SGY-TANK3 Mode D'emploi page 10

OPERATING INSTRUCTIONS
Releasing Air/Draining Water from Tank
NOTE: Before filling the tank it is recommend to drain
any water or air left inside the tank.
Draining the air and condensation from the tank is a
three step process:
Step 1: Remove all attachments from quick-connect
coupler (H) and remove the male plug. Pull the manual
decompression valve ring (located on the front of the
pressure relief valve G), allowing excess air to be
released until gauge (F) reads no higher than 30 PSI
(See Figure 11).
Step 2: Turn the outer screw of the drainage valve (J)
counterclockwise to open valve (See Figure 12).
Step 3: Tilt air tank as shown in Figure 13 to allow air
and condensation to drain freely. Pressure gauge will
read zero after all air has been released. Return air
tank to normal position. Tighten the outer screw valve
fitting by turning it clockwise (See Figure 14).
Do not overtighten.
11
12
13
14
10
G
H
J