2-in-1 Pet Upholstery Tool
*Make sure your clean tank has water & formula to use the tool in wet mode.
1
Follow hose plug-in instructions from
steps 1 & 2 on page 14.
DRY MODE NOTE: Use a "raking" motion to clean. Start with the tool farthest
away and rake in small increments as you bring the tool toward you. The rubber
nubs will help attract hair to the suction channel.
Empty the cup
3
when it fills with hair
and debris.
Turn off the machine.
Hold the cup and twist
counterclockwise line up
the arrow with the unlock
symbol and remove.
7
Wet Mode
(switch
down)
To Deep Clean, move
the switch to wet mode.
Press the trigger to
spray your water and
formula; use the top of
the nozzle to extract
stains and odors.
WET MODE NOTE: Start from the area farthest away. Hold the trigger down, and
pull the tool toward you. Keep the tool in contact with the surface as you pull. You
will see extraction through the nozzle.
4
5
8
Wet
Suction
Channel
To remove any hair or
trapped debris from the
nozzle, first turn off the
machine. Pull the nozzle
tab away from the tool
to remove and rinse
under running water.
2
Dry Mode
(switch up)
Attach the tool and select dry
mode to first pick up dry debris
and pet hair. The suction will be at
the lower part of the tool, near the
dry cup.
Take off the
cup to empty
hair and debris.
Remove hair
that may wrap
around the
filter.
Dry
Suction
Channel
6
To reattach the cup, line
up the cup to the tool
indents, and rotate clock
wise. The arrow will line
up with the locked icon
when secured.
9
Replace to the tool by
lining up the nozzle edge
and snap into place.
Before storing, make
sure all hair is removed
from the dry cup and
nozzle has been rinsed
under running water.
www.BISSELL.ca
13