Bissell PROHEAT 2X REVOLUTION PET PRO 1986 Serie Guide Rapide page 14

Empty Dirty Water Tank
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release dirty water
tank, press down on the
colored tank handle.
4
14
www.BISSELL.ca
2
Tilt the tank slightly
toward you.
For quick empty:
Pull the rubber tab
and tilt to pour.
(Located at the
corner of the top of
the tank.)
When closing the
rubber tab, make
sure all edges are
sealed tight.
For final clean and
rinse: Unscrew the ring
at the bottom of tank.
Gently remove the
float stack, rinse, and
clean.
Once clean, return
float stack into the
tank by lining up the
arrows so they point
at each other. This is
the only way the float
stack will fit into the
tank.
With the arrows
aligned, the float stack
should lock into place.
Return the ring and
twist to lock. Water
may leak if the ring is
not fully tightened.
3
Grab the handle and tank
with both hands and pull
the dirty water tank up
and away to remove.
5
Clean the red filter
below the dirty
tank by wiping off
any remaining dirt
or debris.
6
To return the dirty
tank: Angle the
tank and insert
bottom first. Then
tilt the tank toward
the machine and
push the top in until
it clicks into place.
Did You Know?
The Float Stack
is what prevents
your dirty
tank from
overflowing.