Bissell PROHEAT 2X REVOLUTION PET PRO 1986 Serie Guide Rapide page 17

Replacing Belts & Brush Rolls (Continued)
6
There are washers
at the ends of the
brush rolls, be
careful that these
do not fall off or get
lost.
7
9
Resecure the Wheel and Belt Access Door:
Slide the wheel up back into the slot and
secure with the screw that was removed.
NOTE: See Step 6 on page 18 for hobgw to put the brush roll cover and nozzle
back in place.
NOTE: To replace
brush rolls, remove
them from the
metal posts and
replace. Make sure
the metal post
goes completely
through the end of
the brush roll. The
brush roll bristles
should be aligned
in a 'V' pattern as
pictured.
If the flat belt is broken,
gently remove the belt.
If it needs replacing for
any reason, the gear
belt should already
be removed before
removing the flat belt.
Rotate the machine
back to its side. Feed
the new flat belt
through the opening
so that it wraps around
the red pulley.
Align brush rolls with belt at other
end. To ensure alignment, hold the
end of one brush roll and twist.
The other brush roll rotates with it.
Check that washers are in place.
Reassemble the belt and end cap,
securing with screws you removed.
8
10
Snap the Belt Access Door back
down into place.
Keep it wrapped
on the red pulley
and adjust the
machine so it is
laying on it's back
again. Use your
thumb to stretch
the flat belt back
to wrap around
the metal axle.
www.BISSELL.ca
17