NODOR RDOS 46 Instructions Pour L'usage Et La Maintenance page 7

THIS APPLIANCE IS CONCEIVED FOR DOMESTIC USE ONLY.
THE MANUFACTURER SHALL NOT IN ANY WAY BE HELD
RESPONSIBLE FOR WHATEVER INJURIES OR DAMAGES ARE
CAUSED BY INCORRECT INSTALLATION OR BY UNSUITABLE,
WRONG OR ABSURD USE.
The manufacturer declares that this product meets all the
essential requirements for low voltage electrical material set out
in European directive 2006/95/EEC of 12 December 2006 and for
electromagnetic compatibility as required by European directive
2004/108/EEC of 15 December 2004.
User's Instructions (Fig. 1)
1 Power ON / Power OFF
2 Slider sensor
3 Power key
4 Pause
5 ON/OFF LED
6 Slider LED
7 Pause LED
8 Heating zone and setting display
9 Timer indicator zone
10 Timer
Installation
All operations relative to installation (electric connection) should
be carried out by skilled personnel in conformity with the rules in
force.
As for the specific instructions see part pertaining to installer.
Functionality Slider TC:
Slider: sensor technology of the novel Slider TC allows as well an
adjustment of the cooking levels (1 – 9) as the timer value (1-99)
by touching and pulling the finger over the designated area.
Pulling to the right is increasing and to the left is decreasing
accordant value.
Moreover a direct selection of the designated value is also
possible on the slider area.
ON/OFF Touch Control
After connecting to the mains the TC unit takes 1 second to
prepare for operation. After a reset all displays and LEDs flashes
up for 1 second. After 1 second all displays and LEDs are
switched off again.
The TC unit may now be switched ON by pressing the ON/OFF
key "1". Displays show a steady "0". Possible optic warnings for
hot cooking zones [H] are displayed in alternation with [0] and the
synchronously display dot. The display dots on the cook top
displays flashes up every second (0.5 sec. off, 0.5 sec. on).
Electronics remains activated for 20 seconds. If there is no
cooking level or timer selection done in this period the electronics
automatically resets to the Off-mode by releasing a signal tone.
The TC may only be switched on by pressing the power key as
sole input In case of an other key is pressed (single or in parallel
with the power key), the control unit is not switched on.
By pressing the ON/OFF key "1" of the control unit in ON-Mode,
the Touch Control may be switched off at any time. This is also
applicable for locked control units (active child lock). The ON/OFF
key takes always priority with the POWER-OFF function.
Automatic Switch Off
The TC switches from Power ON to OFF after 20 sec., provided
that no cooking zone is activated or a select key is pressed
during that time.
In case of a selected cooking zone (with cooking stage is "0") this
Auto Power off time is composed of a 10 sec deselection time
and 10 sec Power off time.
ON/OFF Cooking Zone
In case of On-state of the TC a cooking zone may be selected by
touching the dedicated display (Select-Sensors "8"). The
respective display changes to a steady display dot and "0"
instead of "H" – in case of a hot cooking zone-. On all other
cooking zone displays the dot expires.
That followed a cooking level may be set by using the Slider area.
Thus switches the respective cooking zone on. End stops are „9"
(right side) and „0" (left side).
Switching Off a single cooking zone:
A single cooking zone may be switched off by selecting and
setting cooking level to [0]. In case of an optic warning for hot
cooking zones [H] this is displayed in alternation with [0] and the
synchronously display dot.
After the TC is switched Off the display remains black
respectively [H] is displayed for an optic warning for hot cooking
zone.
Switching Off all cooking zones:
Immediately switching off all cooking zones is always possible by
using the ON/OFF key.[H] possibly appears on all hot cooking
zones . All other cooking zone displays remain black.
Power Stages
The power of the cooking zone is adjustable in 9 different stages;
the respective stage is displayed ([1"] to [9]) via LED-seven-
segment-displays.
Automatic Parboiling (selectable)
When Automatic parboiling is activated, the power of the cooking
zone is switched to 100 % for a period of time depending on the
selected onboiling stage. As soon as the parboiling time is over,
the preselected onboiling stage is valid again.
Procedure to start Automatic parboiling:
The control unit is switched on and a cooking zone is selected.