Publicité
Les langues disponibles
Les langues disponibles
standby mode.
· When the control is switched on, the ON/OFF button
has priority over all other button and, therefore, the
control can be switched off at any time, even when
several buttons are pressed at the same time or a
button is kept held down.
· In standby mode, no effect will be caused by buttons
being kept held down. However, before the electronic
control can be switched back on, it has to detect that
no button is pressed down.
Button lock (child safety feature)
• Child safety feature:
Button lock:
To activate the child safety device after turning on the
Touch Control, press and hold the MINUS (2) button.
Then press the button to select the cooking area:
·upper left –> if the hob has 3 cooking areas
·lower left –> if the hob has 4 cooking areas
An "L" standing for LOCKED (child safety feature pre-
venting unintended switch on) will be indicated on all
displays. If a cooking zone is in "hot" mode, "L" and
"H" will be alternately displayed.
This operation must take place within a 10 successi-
ve seconds and no button other than those described
must be pressed. Otherwise, the sequence will be
interrupted and the hob will not be locked.
The electronic control remains locked until it unloc-
ked by the user, even if it has been switched off and
back on meanwhile. Not even touch control resetting
(after a voltage drop) will interrupt the button lock.
Cancelling the button lock:
After switching the touch control on, the child safety
feature can be disabled. Follow the same procedure
as for locking: press and hold the MINUS (2) button,
then press the button to select the cooking area:
·upper left –> if the hob has 3 cooking areas
·lower left –> if the hob has 4 cooking areas
If all operations are completed in the correct order,
the button lock will be cancelled and the touch con-
trol will return to Stand-by mode if no other operation
is carried out within 10 seconds.Otherwise, the se-
quence will be considered incomplete and the touch
control will remain locked and will switch off after
60 seconds.
Switch the touch control back on using the ON/OFF
button and all displays will be indicate "0", the de-
cimal points will flash and the touch control will be
ready for cooking. If a cooking zone is in "hot" mode,
"0" and "H" will be alternately displayed.
Control of multiple circuits
Hobs without double or triple circuit, see Fig. 2A
Hob with triple zone. (Fig. 2B)
When a dual / triple cooking zone is activated, the 3
circuits are switched on at the same time. The activa-
tion / deactivation of each circuit is done with button
4 and it is indicated with an illuminated segment (8).
Sound signal (buzzer)
The following activities are indicated by a buzzer du-
ring use:
· Normal button pressing by a short sound.
· Buttons kept pressed down for more than 10 sec. by
a long, intermittent sound.
Timer function (optional)
The timer function is realized in two versions:
· Stand-alone timer 1..99 min: sound signal when the
time is over (= minute minder). This function is only
available when the cooktop is not in operation, i.e.
when there is no cooking.
· Cooking zone timer 1..99 min: sound signal when
the time is over, four cooking zones can be program-
med independently.
Timer as minute minder (stand-alone):
· If the control is ON and no cooking zone selected,
the standalone-timer can be used by simultaneously
operating MINUS (2) and PLUS (3) keys.
· Adjustment range (0-99min), it can be set in 1-mi-
nute steps with any key, starting at 1 up to 99 (end
stop) with the minus-key starting at 99 down to 0
(end stop)
· Continuous activation of the plusor minus-key re-
sults in a dynamic increase of the adjustment speed
up to maximum value without sound signal.
· when the plus- or minus key is released in the
meantime, the adjustment speed starts again from
a (low) initial value.
· adjustment can be made with a continously activa-
ted plusor minus-key or by tip-operation (with sound
signal) After the timer is set the time runs down
according to the adjustment. When the time is over
there is a sound signal and the timer display blinks.
Publicité
