Stanley FATMAX DST 101/8/6 Manuel Utilisateur page 20

any part of the casing unless qualified to do so; this unit
contains dangerous voltages.
G
Warning!
B
For your protection if this product is to be used outdoors it
should not be exposed to rain or used in damp locations. Do
not place the product on damp surfaces, use a workbench
if available. For added protection use a suitable residual
current device (R.C.D.) at the socket outlet.
Note: If the mains cable requires replacing it must be
replaced with an identical one and fitted by a qualified
person.
5.4 I/O switch (On/Off) (ref. 8)
To switch on the equipment set the On/Off switch (ref. 8)
to position I.
Move the On/Off switch (ref. 8) to position O to switch off
the equipment.
Warning!
After switching off the compressor, you must wait
three seconds before switching on the machine again.
5.5 Adjusting the pressure
● You can adjust the pressure on the pressure gauge (ref.
6) using the pressure regulator (ref. 7).
● The set pressure can be taken from the quicklock
coupling (ref. 5).
5.6 Setting the pressure switch
The pressure switch is set at the factory.
● When the upper calibration value (set by the manufacturer)
has been reached, the compressor stops.
When air is used, the compressor restarts automatically
when the lower calibration value is reached.
● The compressor continues to operate according to this
automatic cycle until the I/O switch is turned.
FUNCTION
Cleaning of intake filter and/or
substitution of filtering element
Draining tank condensate
6. CLEANING AND MAINTENANCE
Pull the power plug before doing any cleaning and
maintenance work on the appliance.
Wait until the compressor has completely cooled
down. Risk of burns!
Always depressurize the tank before carrying out any
cleaning and maintenance work.
6.1 Cleaning
● Keep the safety devices free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
● We recommend that you clean the appliance immediately
after you use it.
● Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure
that no water can get into the interior of the appliance.
● You must disconnect the hose and any pneumatic tools
from the compressor before cleaning. Do not clean the
compressor with water, solvents or the like.
6.2 Condensation water (Fig. 4)
The condensation water must be drained off each day
by opening the drain valve (ref. 11) (on the bottom of the
pressure vessel).
Dispose
environmentally compatible manner at the appropriate
collection point.
6.3 Safety valve (ref. 10)
The safety valve has been set for the highest permitted
pressure of the pressure vessel. It is prohibited to adjust
the safety valve. Actuate the safety valve from time to
time to ensure that it works when required. Pull the ring
with sufficient force until you can hear the compressed air
being released (Fig. 6). Then release the ring again.
MAINTENANCE RESUMPTIVE TABLE
AFTER THE FIRST
100 HOURS
●
Daily and at the end of work
20
Warning!
Warning!
Warning!
Warning!
of the condensation
EVERY 100 HOURS
●
water in an